You have no items to compare.
Features
• Absolutely Odor Free
• No VOCs
• No Enzymes
• Nontoxic
• Colorless
• Hypoallergenic
• No Soapy Sticky Residue
• RTU pH 7.6
COVERAGE:One gallon will cover approximately 10,000 sq. ft.
ENVIRONMENTALLY SAFER - This product meets the Green Seal™ environmental standard for industrial and institutional cleaners based on its reduced human and environmental toxicity and reduced volatile organic compound content.
PROCYON products have been tested and approved for indoor air quality; our products contain no volatile organic compounds (NO VOC’s) and no fragrance has been added. PROCYON can be used in enclosed areas without the worry of harmful off gases.
CONTAINS: nonionic surfactant, water softening agents and natural degreasers.
PROCYON Extreme! Carpet Cleaner is unique in that it starts with a pH of 11.5 concentrated, but when mixed to RTU (just 4 oz. to a gallon), the pH drops to 7.6, which means it is safe and effective for even the most delicate fibers.
Easily clean extremely neglected commercial carpets as well as the “hard to clean” carpets manufactured with olefin or acrylic fibers for example. You can effortlessly plow through heavy oil & grease-soiled restaurant carpets and always come up with excellent results. Removes ground in dirt from severely soiled traffic lanes, it will also remove tough spots & stains caused by blood, various inks, road tar, gum, ketchup, shoe polish, tea, coffee, food and beverage residues, and more!
Mix with hot or cold water and use as a pre-spray or with cleaning systems such as truck mounts, steam cleaners, portable extractors, rotary scrubbers as well as for bonnet cleaning or encapsulation. It offers you enormous cost savings by eliminating the need for a huge list of cleaning solutions such as traffic lane pre-sprays, defoamers, and acidic rinse agents. And, with its exceptional dilution ratio, each gallon will cover approximately 10,000 sq. ft.
When it comes to restoring a carpet, Soap Free Procyon® Extreme! is a wonderful product that you can count on to get the toughest job done! Even if you have new carpet and it is time for them to be cleaned “do not use soap!” It will leave a sticky residue. Some will say, “We rinse the soap out”. Yes, you think you might be rinsing the soap out, but you cannot get the entire soapy, sticky, detergent residue out of a carpet.
Think of the washing machine. A washing machine goes through 3 rinse cycles just to get the soap out of your clothes. If you stop and think about that for a moment, that is a lot of water. Three rinse cycles just to get the
detergent out of your clothes!
Now think about rinsing the detergent out of your carpet. How much water do you use to rinse the soap out of the carpet? If you used the same amount of water to get the soap out of your carpet as your washing machine uses to get the detergent out of your clothes, you will have some wet carpet, mold, mildew and indoor air quality issues. Plus it would take days for your cleaning job to dry. Wet carpets cause mold, mildew and bacteria and we know that this is not a safe and healthy choice.
Helpful Carpet Hints for using Soap free Procyon Extreme!
Soap free Procyon Extreme! can be used with all types of cleaning equipment from truck mounts, portable extractors and low moisture cleaning systems. Try our cleaning product as a pre spray in front of any piece of cleaning system and you will love your results.
Wicking, Browing Problem Carpets: Solving wicking, browning using Soap Free Procyon Extreme! as a prespray will dissolve the detergent residue and soil from the carpet fiber leaving the tips of the fiber all natural and soap free. The next step you will want to take is fresh water extract to start the removal of the soil and detergent residue from the fiber leaving the fiber soap free. Then you need to use our special thick 100% all natural cotton bonnet covering 300 square feet per side to… almost dry the tips of the fiber. So when the wicking process can not start, the moisture cannot rise back to the tips of the fiber. Why: Once you have removed the detergent from the fiber, the tips of the fiber will be free of the soap. You can now run our cotton bonnet across the fiber removing the moisture and almost dry the tips. This method will stop your wicking problem.
Extreme Problem Carpet: Solving wicking problems for some carpet can present a challenge. “Caution: you may not want to extract because any amount of moisture could cause over wetting.” First you can pre-spray to dissolve the soil and detergent residue from the tips of the fiber. Use a special 100% all natural cotton bonnet to almost dry the tips of the fiber. This process can stop wicking.
In extreme cases where you cannot pre-spray or extract, you will want to use our special 100% all natural cotton bonnet using Soap Free Procyon Extreme! in a mop bucket with a wringer. Dip your 100 % cotton bonnet in to the mixed solution wring out the bonnet pad and place the cotton pad on top of the dry carpet in an area away from the wicking problem. Place your buffer on top of the wet bonnet and spin it out moving the bonnet across the soiled area removing the soil, cleaning the area. Keep the bonnet moving do not stop until you are ready to flip the bonnet or stop the cleaning. Always stop your cleaning system in an out of the way area that wicking has not occurred.
In some cases: a bonnet cannot be used to remove moisture from the tips of the fiber. Using Soap Free Procyon Extreme!, extract the carpet fiber removing the soap with out over wetting…dry extract and remove all the moisture from the fiber that you can. Next: use drying machines to dry the problem area fast is the key to your success.
• No VOCs
• No Enzymes
• Nontoxic
• Colorless
• Hypoallergenic
• No Soapy Sticky Residue
• RTU pH 7.6
COVERAGE:One gallon will cover approximately 10,000 sq. ft.
ENVIRONMENTALLY SAFER - This product meets the Green Seal™ environmental standard for industrial and institutional cleaners based on its reduced human and environmental toxicity and reduced volatile organic compound content.
PROCYON products have been tested and approved for indoor air quality; our products contain no volatile organic compounds (NO VOC’s) and no fragrance has been added. PROCYON can be used in enclosed areas without the worry of harmful off gases.
CONTAINS: nonionic surfactant, water softening agents and natural degreasers.
PROCYON Extreme! Carpet Cleaner is unique in that it starts with a pH of 11.5 concentrated, but when mixed to RTU (just 4 oz. to a gallon), the pH drops to 7.6, which means it is safe and effective for even the most delicate fibers.
Easily clean extremely neglected commercial carpets as well as the “hard to clean” carpets manufactured with olefin or acrylic fibers for example. You can effortlessly plow through heavy oil & grease-soiled restaurant carpets and always come up with excellent results. Removes ground in dirt from severely soiled traffic lanes, it will also remove tough spots & stains caused by blood, various inks, road tar, gum, ketchup, shoe polish, tea, coffee, food and beverage residues, and more!
Mix with hot or cold water and use as a pre-spray or with cleaning systems such as truck mounts, steam cleaners, portable extractors, rotary scrubbers as well as for bonnet cleaning or encapsulation. It offers you enormous cost savings by eliminating the need for a huge list of cleaning solutions such as traffic lane pre-sprays, defoamers, and acidic rinse agents. And, with its exceptional dilution ratio, each gallon will cover approximately 10,000 sq. ft.
When it comes to restoring a carpet, Soap Free Procyon® Extreme! is a wonderful product that you can count on to get the toughest job done! Even if you have new carpet and it is time for them to be cleaned “do not use soap!” It will leave a sticky residue. Some will say, “We rinse the soap out”. Yes, you think you might be rinsing the soap out, but you cannot get the entire soapy, sticky, detergent residue out of a carpet.
Think of the washing machine. A washing machine goes through 3 rinse cycles just to get the soap out of your clothes. If you stop and think about that for a moment, that is a lot of water. Three rinse cycles just to get the
detergent out of your clothes!
Now think about rinsing the detergent out of your carpet. How much water do you use to rinse the soap out of the carpet? If you used the same amount of water to get the soap out of your carpet as your washing machine uses to get the detergent out of your clothes, you will have some wet carpet, mold, mildew and indoor air quality issues. Plus it would take days for your cleaning job to dry. Wet carpets cause mold, mildew and bacteria and we know that this is not a safe and healthy choice.
Helpful Carpet Hints for using Soap free Procyon Extreme!
Soap free Procyon Extreme! can be used with all types of cleaning equipment from truck mounts, portable extractors and low moisture cleaning systems. Try our cleaning product as a pre spray in front of any piece of cleaning system and you will love your results.
Wicking, Browing Problem Carpets: Solving wicking, browning using Soap Free Procyon Extreme! as a prespray will dissolve the detergent residue and soil from the carpet fiber leaving the tips of the fiber all natural and soap free. The next step you will want to take is fresh water extract to start the removal of the soil and detergent residue from the fiber leaving the fiber soap free. Then you need to use our special thick 100% all natural cotton bonnet covering 300 square feet per side to… almost dry the tips of the fiber. So when the wicking process can not start, the moisture cannot rise back to the tips of the fiber. Why: Once you have removed the detergent from the fiber, the tips of the fiber will be free of the soap. You can now run our cotton bonnet across the fiber removing the moisture and almost dry the tips. This method will stop your wicking problem.
Extreme Problem Carpet: Solving wicking problems for some carpet can present a challenge. “Caution: you may not want to extract because any amount of moisture could cause over wetting.” First you can pre-spray to dissolve the soil and detergent residue from the tips of the fiber. Use a special 100% all natural cotton bonnet to almost dry the tips of the fiber. This process can stop wicking.
In extreme cases where you cannot pre-spray or extract, you will want to use our special 100% all natural cotton bonnet using Soap Free Procyon Extreme! in a mop bucket with a wringer. Dip your 100 % cotton bonnet in to the mixed solution wring out the bonnet pad and place the cotton pad on top of the dry carpet in an area away from the wicking problem. Place your buffer on top of the wet bonnet and spin it out moving the bonnet across the soiled area removing the soil, cleaning the area. Keep the bonnet moving do not stop until you are ready to flip the bonnet or stop the cleaning. Always stop your cleaning system in an out of the way area that wicking has not occurred.
In some cases: a bonnet cannot be used to remove moisture from the tips of the fiber. Using Soap Free Procyon Extreme!, extract the carpet fiber removing the soap with out over wetting…dry extract and remove all the moisture from the fiber that you can. Next: use drying machines to dry the problem area fast is the key to your success.
Additional Information
| SKU | PROC82835-EXTREME-GRP |
| Manufacturer | Procyon |
| Application / Use | Prespray, Extraction, Encapsultion, Bonnet, Wicking & Browning, Upholstery, Rugs, Most fibers |
| Dilution(s) | PRE-SPRAY/EXTRACTION: For use on heavily soiled carpet traffic areas. Effectively dissolves grease, dirt, grime, spots and stains. Mix 4 oz. to 1 gallon of COLD, WARM, or HOT water. Pre-spray evenly. DO NOT OVER WET. Let dwell for 10 minutes. Extract with fresh water. PORTABLE EXTRACTION (without pre-spray): Mix 4 oz. to 1 gallon of COLD, WARM, or HOT water. For all portable extractors including extractors with a siphon tube. In this case, simply place the siphon tube into the concentrated liquid. ENCAPSULATION PRE-SPRAY: Mix 4 oz. to 1 gallon of COLD, WARM or HOT water - agitate. After fiber dries, vacuum thoroughly. BONNET CLEANING: Mix 4 oz. to 1 gallon of COLD, WARM, or HOT water. Pre-spray evenly on heavily soiled area. Let dwell for 10 minutes. For best results, bonnet using 100% cotton bonnet pads. WICKING & BROWNING: Mix 2 oz. to 1 gallon of COLD, WARM or HOT water. Pre-spray the carpet fiber. DO NOT OVER WET. Let dwell for 10 minutes. For best results bonnet using 100% cotton bonnet pads to absorb moisture and to prevent wicking or browning problems. UPHOLSTERY: Mix 2 oz. to 1 gallon of COLD or WARM water. Pre-spray evenly, applying from the base of the upholstery going up and extract from the top going down. HYDRO FORCE: Mix 32 oz. to 1 gallon WARM or HOT water (meter 1:8). Apply evenly. Let dwell for 10 minutes. TRUCK MOUNT: Fresh water rinse. Set heat at 180° to 200° F. NOTE: Rinsing agents are not needed. |
| Approvals | CRI Approval Green Seal Certified WoolSafe Approved IAQ Approval |
| Automatic Discounts | Buy 4 Gallons and Receive 10% OFF |
| Packaging | 1 Gallon | 4 Gallons/Case |
| pH | 11.4 Concentrated | 7.6 @ Ready to Use dilution |
| S.D.S. | Left Click to view .PDF | Right Click and Save Link As to Download .PDF |
| Manufacturer Link(s) |
You may also be interested in the following product(s)
|
Procyon Plus Powder
Starting at: $37.37
|
Procyon Tile, Grout, Stone Cleaner
Starting at: $31.52
|
